Complex system for mixing the thermal agent required for underfloor heating with 8 circuits, ideal for 70-85 square meters, Maximum length of the pipeline on the route 90 meters Calculation generated at a step of 10 cm. Consisting of : 1 x distributor set 7 circuits with flowmeters 1 x distributor set 7 circuits with valves (possibility of connecting the actuator with the command to the room thermostat) 1 x distributor clamp set 14 x eurocone nut for pex pipe 16 mm x 2 mm thick (pe-xa,pe-xb,pe-xc,pe-rt) 2 x distributor end tee with automatic vent and emptying 1 x mixing group for underfloor heating 1 x Wilo Yonos Para 25/6 pump Technical details: Distributor with flow meter 1"x 7 ways + eurocone nuts 16mm + distributor end tee with automatic aerator and emptying 1 x 1" x 7-way stainless steel distributor set with thermostatic valves (predisposition for mounting a thermoelectric head (actuator) for automation on each circuit) 1 x 1" x 7 stainless steel distributor set with flow meter (to adjust the flow on each circuit depending on the length of the pipe used in the circuit) 1 x Distributor mounting set consisting of 2 consoles 10 x Eurocon nut 16×3/4 (to make the connection from the distributor to the pe-xa, pe-xb, pe-xc, pe-rt of 16mm with 2mm thickness 16×2) 2 x distributor end tee 1" (automatic air vent for removing the air from the distributors, emptying valve) Maximum pressure 10 bars Maximum temperature 90 degrees C Underfloor heating unit equipped with Wilo Yonos Para 25/6 pump Available with fixed adjustment through the thermostat head with probe: adjustment range 20 - 60 degrees C. The inlet valve controlled by the thermostatic head allows adjusting the inlet temperature of the heating agent supplied by the boiler to maintain a constant temperature in the floor It allows mixing between the heating agent supplied by the boiler and the one on the floor return.